Ardupilot has option for Spectrum SRLX2 protocol?
@mykemu wrote: I couldn’t find a serial6 protocol option in Mission Planner for my Spektum receiver that uses SRLX2. Am I out of luck Posts: 2 Participants: 2 Read full topic
View ArticlePID tuning in the air
@xixijoe wrote: Hello, Can I tune the PID and FF while the plane in the air? I found the result of autotune is always kinda overshooting. what is reason could be? what params should I check before...
View ArticleClik here to view.
Slowly accending
@xixijoe wrote: Hello, when the plane fly to the next wp with higher attitude. it always accending immediatly to the atitude. How can I set it reaching the altitude with arriving the wp? Thank you for...
View ArticleMatek f765 for quad plane
@cochrane771 wrote: Hi all I am new to the forum and arduplane I am trying to build a mini talon quadplane -the board is flashed and accelerometer calibrated -q enable 1 -I have all the servos working...
View ArticleM8N battery replacement?
@govsux1 wrote: Sorry I know this isn’t 4.1 related but I can’t seem find info on google. Strange. Anyway… My m8N seems to take a long time… like 2 minutes or more … to get a decent lock. Not just the...
View ArticleCAM trigger not working properly
@KadaverJoe wrote: I am using ArduPlane for many years and I am very satisfied with the work of it and the development! We use fixed wing planes for mapping applications on our arable farm. ArduPlane...
View ArticleCrash -- Pitch control stuck after switching out of AUTOTUNE
@N_A1 wrote: Hello there, been flying Arduplane 4.1 beta3 (FC: MAtek h743 wing, plane: volantex ranger EX) and wanted to autotune the vehicle. Shortly after take off, I switched to autotune...
View ArticleAutotune Beta3 ARWing
@Allister wrote: @tridge, first think I need to say is I’m pretty pleased. Thank you for all the hard work you and the other devs have put into this. This is the first time I’ve been pleased with an...
View ArticleBeta 3 observations
@Allister wrote: Just some general observations about Beta 3 (not related to autotune) Mission planner seemed to have a hard time finding the flight log list. Several times it would time out and I...
View ArticleClik here to view.
PID tuning not successful
@xixijoe wrote: Hello, I have noticed that the target rate and the actual rate are supposed to get closer as the tuning is going forward. but it did not happen on my case. what did I do wrong? I...
View ArticleVTOL connection issue with dronekit
@MuhammedZEYN wrote: Hello, I have problem on communication raspberry pi to pixhawk cube orange with dronekit. When I use Q_Enable_Mode=1 (VTOL Mode) and SERIAL2_BAUD=921, LOG_BACKEND_TYPE=2...
View ArticleMatek405wing bizarre servo behavior upon radio shutoff
@Benc wrote: I have matekf405 wing FC in AR900 wing . This has flown before , about a dozen flights . I’ve never went so far out where my radio link failed . On the bench I just discovered that when I...
View ArticleVtol crashed during rtl, please help
@ton999 wrote: Today I just got big problem, my new VTOL is crashed during RTL. I take off using QSTABILIZE, then QLOITER, then FBWA. After a while changed mode to RTL , but the plane climb higher and...
View ArticleUncommanded quadplane low-altitude RTL (4.1.0 Beta1), CUAV V5+
@Chris_Heintz wrote: Hi all, Had an aircraft perform an unexpected RTL right after takeoff without any apparent command (failsafe, ground station, RC), resulting in a mild crash (landed out of sight)....
View ArticleFlaps Don't Open
@Nil_DUMAN wrote: Hi I have changed flap1 speed, flap1 Percent,Slewrate. I have set the servo outputs to Flap Auto but the UAV still wont’t open flaps. It only open during takeoffs. Please help me,...
View ArticleClik here to view.
VTOL RTL and LANDING ISSUE
@marstears wrote: VTOL Plane: QuadPlane with forward motor Firmware: ArduPlane 4.0.9 FC: Pixhawk2 CubeOrange I followed the wiki to set Q_RTL_MODE=2 to make my plane RTL as a normal fixed wing and...
View ArticleMultiple firmwares available for FC . What is difference?
@Benc wrote: Just a simple question . I’m downloading beta version of arduplane 4.1.0 For MATEK H743 there are two firmwares listed for the same version . One says only matek h743 while the other says...
View ArticleClik here to view.
ArduPilot Plane 'aerobatic' mission
@andyp wrote: Hi. Is there still anyone interested in adding aerobatic maneuvers to autonomous missions? I would like to add something quite ‘simple’ () - have two waypoints. Fly from A to B, and at B...
View ArticlePlane 4.1.0 CRSF and smart audio non functional . MATEKH743wing
@Benc wrote: MATEK743WING_1.param (20.0 KB) Assembled MATEKH743wing FC on bench using related peripheral hardware to test functionality of CRSF and smart audio . I used both a tbs smart audio eachine...
View ArticleServo output not reading throttle
@kadir_babacan wrote: Hi everybody, I have pixhawk orange. In the “radio calibration” part, the throttle and all other bars move. In the “servo output” part, the other bars respond, but the throttle...
View Article