@Benc wrote:
I have matekf405 wing FC in AR900 wing . This has flown before , about a dozen flights . I’ve never went so far out where my radio link failed .
On the bench I just discovered that when I shut off my transmitter the servos go nuts , jittering all over the place . When and if they settle down the wing ……which is level on bench in STAB mode …… places elevens in a hard left roll position and keeps them there .
Does this mean If I fail safe in field the wing will spiral into ground instead of RTL ?
Also I notice sometimes I have to disconnect and reconnect power several times to get the FC to initialize . That never happened before .
I’ve tried both analog and digital servos , no difference . The flaky behavior is being commanded by FC .
I recently installed analog airspeed sensor , have not flown it yet . I already tried changing all the airspeed sensor settings back to that of a board without one , no difference .
Arduplane 4.0.9 firmware .
Posts: 3
Participants: 2