Getting rxrssi value
@Mustafa_Gokce wrote: Hi. I was be able to transmit the rssi of the rc communication in channel 10 and i can see the rssi increasing and decreasing in the rc calibration page.How can i input this...
View ArticleCode modificaton
@dinesh286 wrote: Hi,I want to modify the arduplane code for autonomous landing. I want to put my own landing algorithm. How to go abt code modification for landing. I relatively new to arduplane code...
View ArticleClik here to view.
Problem with roll in RTL mode
@issam_Boukerch wrote: I have aprduplane 3.4 on APM pro.After installation and autotune the plane flies well in FBWA and auto, after this I installed the airspeed sensor, in the calibration flight I...
View ArticleClik here to view.
QuadPlane Conversion of Hobby King Bix3 Trainer (cont.)
@GregCovey wrote: This is a continuation of my Bix3 QuadPlane thread using the Plane v3.8.3 firmware release. I'll link this thread to my original one here which used v3.6.0 firmware. Hobby King has...
View ArticleRSSI only showing 0% or 100%
@Clement_FPV wrote: Hello, I've been having a lot of problems on arduplane 3.8 to get rssi from my dragonlink.I used to put a wire between my rx and pixhawk like with the APM which worked great,...
View ArticleUsing Airspeed sensor capable of operating up to 140 m/s
@Karthik_A wrote: Dear All,Anyone recommend an airspeed sensor capable of operating up to 140 m/s. From the market research, Eagle tree Microsensor V3 seems to be a good contender. I am planning to...
View ArticleWrong attitude at startup
@Alessandro wrote: Hi all,on my drone (plane) I had to mount the pixhawk with a different orientation because of space constraints.The current orientation is as follows: the arrow on the pixhawk...
View ArticleIs Mission Planner Arduplane SITL working?
@Gary_Mortimer wrote: Since yesterdays Misson Planner update I have been having issues, it could very well be me. I have tried on 1.3.50 and 1.3.51.1 but no joy. It was working until I updated. Posts:...
View ArticleIs GUIDED mode broken in Plane 3.8.3?
@armadillo wrote: Hello, I just flashed Plane 3.8.3 and got strange results in two different planes. Basically, GUIDED does not seem to be doing anything. I tried it on a plane with a 3DR Pixhawk and...
View ArticleLIM_PITCH_MIN - clarification needed
@anparkinson wrote: In Mission Planner there is the LIM_PITCH_MIN described as "The minimum commanded pitch down angle." I understand this that if I set it to 20 then the plane will dive at a minimum...
View ArticleSet waypoints without specifying an altitude
@nich-12 wrote: Hi, I want to drop a glider from a relatively high altitude and let it glide through waypoints. Since it will only glide, no propeller is going to be on the glider. I only want the...
View ArticleNew to ArduPilot
@Milan wrote: Hello everybody, This forum is all new to me.I do not understand how it works.I have a Raspi, an RC splope flying wing and I would like to autopilot it.Could you please help me to find...
View ArticleQ_assist Fixed wing takeoff
@Barry_Bolton wrote: Hello and thank you for reading. I want to test a couple of take off procedures with my Volantex Ranger. At the moment the plane weighs close to 2800grams and is a little heavy. I...
View ArticleClik here to view.
Baby it's Cold Outside, Bad Compass Health?
@flyingw wrote: Took a flight today in cold, windy 20 degree weather here in Northwest New Jersey. I'm using a Navio2 with ArduPlane 3.7.1. My external compass is a tiny HMC5983 board that is mounted...
View Article.tlog wanted for testing
@yak-54 wrote: Hi all i am looking for some .tlog for testing an osd in a simulator ( plane ) take off auto mission and land Posts: 1 Participants: 1 Read full topic
View ArticleDevelop IMU Sensors Of Ardupilot
@sccstart wrote: HI ..Iam traying to change ardupilot code to work with any IMU that support SPI protocolbut i have problem when make change in AP_InertialSensor exact on...
View ArticleHow to tell a servo goes bad in flight?
@Anthony wrote: Has anybody put any thought into this and what to do when this happens? Posts: 1 Participants: 1 Read full topic
View ArticleRealFlight SITL plane flies vertical
@thatsnailguy wrote: Helo, all There must be something simple I am missing, I have the SITL interfaced with RealFlight 8. Copter works great! But plane feels like the the ahrs orientation is 90...
View ArticleCan a plane navigate a mission without the compass?
@flyingw wrote: I recently ran a mission where Mission Planner reported the "Bad compass Health" alarm. The heading was changing correctly on the ground so I took off and tried a short mission. The...
View ArticleTiltrotor Issues
@StudentX1 wrote: Hi all, I'm building a tilt tricopter using QuadPlane setup. I'm not sure why the motors don't work when in Q_Stabilize mode (when the motors are facing up). There's no response when...
View Article