@Clement_FPV wrote:
Hello, I've been having a lot of problems on arduplane 3.8 to get rssi from my dragonlink.
I used to put a wire between my rx and pixhawk like with the APM which worked great, however on my new config, I decided to get rid of the cable and setup my dragonlink rx to output rssi on channel 8 within the ppm stream.(my flight modes are on ch5)In Mission Planner, I correctly configured rssi_chan=8; rssi_type=pwm; min_pwm=1916 max=1992.
I f I check in radio calibration, I can see this channel moving constantly like it should, however when I look in the Quick view datas as well as on my osd, the rssi is 0% when radio turned off, and 100% when turned on, there is no middle value.I could just plug the cable back but I'm to frustrated from not making such a simple thing work.
Posts: 5
Participants: 2