Dual motor tailsitter
@vinod_nayak wrote: Hi team, Its been a long time im working on cube. I have successfully made quad plane with cube and few other projects and they were grand success. Now i am working on Dual motor...
View ArticleNot holding heading during flare? .bin logfiles provided
@Christopher_Milner wrote: Arduplane 4.0, Pixhawk4, Rudder-only airplane. Any thoughts/diagnosis/suggested tests would be much appreciated! Logfile, bin format, here: drive.google.com 00000007.BIN...
View ArticleClik here to view.
Minimum distance to avoid interference
@Centomini wrote: Hi everyone, I should mount the battery and the external magnetometer (3DR GNSS/Compass) as per the attached image. The distance between the two elements would be 5 cm. Do you think...
View ArticlePixhawk 2.1 randomly reset parameters
@lakhe85 wrote: Hi everyone, I’m operating a Nimbus VTOL plane and she flies great running 3.9.8 firmware. But 2 weeks ago, when I plugged the battery, suddenly all parameters in the Pixhawk were...
View ArticleClik here to view.
Servo out trim at pwm 1100
@xingxing wrote: Guys,my F405 Wing was flashed arduplane3.9.9,but the servo output trim at 1100,but I have set it at 1500,can some people give any suggestion to solve the problems...
View ArticleClik here to view.
Bad Gyro Health SITL Plane 4.1.0
@flyespen wrote: SITL_PLANE_27-12-2019 17-29-27.gif1362×760 327 KB Well, I am a newbee with Arduplane, but I manage this SITL for the copter. I had recently calibrated the Pixhawk (bought on HK some...
View ArticlePlease add vibe parameter on osd
@xingxing wrote: My rambler RS crashed due to vibZ high. For the aircraft landing with the belly, it is inevitable that there will be a little wear and tear on the propeller. If the wear on both sides...
View ArticleNoob looking for starting direction, with a parrot disco
@fastesteddy wrote: Hi all… Just bought a Disco for my son, but I know that quickly I will be playing with it more than he will… Just starting to get an idea of the mammoth learning curve needed to...
View ArticleServo output disabled
@faduplooy wrote: Good day all Im trying trying to setup my APM in my glider. I have 2 aileron servos on separate channels( so that i can do crow braking and have stabilization on both ailerons) ....
View ArticleVibration damping for pixhawk 2.1
@Rafi wrote: Hi, I am using a cube black for my 62 cc single cylinder gas plane.My planes wingspan is 2200cm. Should I hard mount it or use gel pads? I have Kyosho gel pads available. Posts: 3...
View ArticleSparkFun F9 Pixhawk Cube Integration
@skyveyor wrote: Happy New Year! I am thrilled to see support for the U Blox F9 in Plane release 4.02. Thanks to Trige and all other developers for the continued development and their support. With...
View ArticleMatek F405-WING Telemetry radio on UART 4
@csmicfool wrote: I’m trying to wire up an F405 with the following accessories: FrSky Rx on SBUS + S.Port Telemetry Radio (Tried on UARTs 3 and 4) FrSky Rx and telemetry working fine, but I can’t get...
View ArticleClik here to view.
Rambler RS crash equipted with F405 WING
@xingxing wrote: Hi,ALL， Rambler RS is really a good plane,and it has been safety flight for 7 hours(FLT TIME),But in the last few flights, it became random maneuver which cause the plane crash. The...
View ArticleIncrease Heartbeat Message Sent Over Mavlink
@ralex wrote: I am looking for a way to send heartbeat messages over mavlink at a frequency of 5-10hz instead of 1hz. Right now in plane 3.9.11, it appears that a heartbeat is sent every one second as...
View ArticleMatek F405 - 9th servo output not showing up
@jpgoblin wrote: Trying to use all 9 servo outputs on the F405 flight controller but the 9th servo isn’t showing up in the Servo Ouput tab. BRD_PWM_COUNT is set to 9. Anyone seen this before or know...
View ArticleVTOL quadplane with SITL and Gazebo
@juandediosyanez wrote: Good evening @all, I am trying to simulate a quadplane / vtol in Gazebo but I am not successful. I understand that you have to modify the standard_vtol PX4 model to work with...
View ArticleNew User & New project - Deciding on Firmware/Vehicle type to suit mission
@Berto wrote: Hello Everyone, I’ll try to keep this short-ish; I’m a new user, and hopefully not the first to be a little overwhelmed by the scale of choice available. There’s an awful lot to read and...
View ArticleOSD: Other aircraft's location?
@mike_d wrote: Recently I stumbled upon a feature in another flight control system called FlyTogether by MyFlyDream. Essentially, it paints an indicator in your OSD to show another aircraft’s heading,...
View ArticleClik here to view.
Never ending loiter in WP
@korakora wrote: i have very strange experience with WP Mission which i never ever had before but first let me start to describe with this points i don’t have any log because i’m using omnibus with...
View ArticleESC Telemetry as Power Module
@tiana wrote: Hello, I have small idea for firmware improvement. Now the BL-Heli support is available and FC can read telemetry from the ESC. Why the ESC telemetry is not appear in power tab, to be...
View Article