Bad launch auto
@RodrigoMeirelles wrote: Hello everyone! I’m having trouble with my fixed wing on takeoff. When I launch at BUNGEE LAUNCHER, he leans sideways and hits the floor. In MISSION PLANNER displays the...
View ArticleHow to change Telemetry Radio UART on Matek F-405 Wing
@Alexander_Perez wrote: Hello. I’m trying to assign a different Uart for the telemetry radio. By default, it appears only to work on UART 1. I’d like to assign it to UART 2. Can someone point me to...
View ArticleSynthetic Airspeed malfunction (2nd time)
@Ed_209 wrote: I experienced a malfunction of the airspeed reading today during a flight. It appears to be the same thing that happened last month which caused my Mini Talon to crash. This time it was...
View ArticleArdupilot’s SITL: Simulation of ADS-B enabled aircraft
@sebjet wrote: How can I show live ADS-B Traffic in QGroundControl by using: sim_vehicle.py -v ArduCopter -A “–uartC uart:$SERIAL_DEVICE:57600” Is it working with vagrant ? Does QGroundControl show...
View ArticleClik here to view.
Wing with pixhawk4/FW-ardupilot flies curvy straights
@Titanex7 wrote: I fly a Skywalker X8 with the Pixhawk4 (FMUv5) with the Pixhawk FW. Everything is programmed via QGrouncontrol on the tablet. Flying so well, had to set only the roll / pitch PID...
View ArticleAttitude output from telemetry prot
@jesus_taax wrote: Dear all, I need 100hz attitude data in the telemetry port. With the SR params we only have around 10hz refresh rate: SR0_EXT_STAT,3 SR0_EXTRA1,10 SR0_EXTRA2,10 SR0_EXTRA3,3...
View ArticleClik here to view.
MATEK F405 WING can't display vetical speed
@xingxing wrote: Hi,the F405 WING have installed arduplane firmware 3.9.9,every things seems fine except it can’t display vetical speed value ,but the arrow on the left of the vetical speed value...
View ArticleQuick tilt-tricopter rear motor question
@ocularmagic wrote: I just have a quick question I’m hoping someone can answer regarding the rear motor of a Tilt-Tricopter. When the tricopter is in full forward flight mode, with the two front...
View ArticleClik here to view.
Quad Tilt Wing VTOL Setup
@seth_poh wrote: Hi all, I am currently planning a build a quad tilt wing VTOL platform similar to this platform from GHCraft amongst many others: ghcraft_qtw.jpg800×600 75.3 KB I am now trying to get...
View ArticleClik here to view.
PX4 and Ardupilot compare
@smilie wrote: Does anyone have the opportunity to take a look here? PX4 Discussion Forum, PX4, QGroundControl, MAVSDK, MAVLink – 9 Oct 19 Slight Flyaway problem I was flying my drone earlier today....
View ArticleDive flight recovery from -90 degrees pitch
@Barnaba wrote: Hello to all, It’s my first post here, I’m building an experimental plane, I was looking for solutions few days without success. I recently crashed with some unusual issue. My drone (5...
View ArticleWhat ArduPlane firmware does VTOL? Rotors with 2 degrees of freedom?
@Jake_Fitzpatrick wrote: I’m doing a project, and we need a fixed wing drone that has vertical take off and landing capabilities. We are also trying to make the rotors on a gimbal, giving it 2 degrees...
View ArticleSITL JSBSim + FLightGear
@Albcem wrote: Hello all, I have a little esthetical problem. I built a custom plane model using JSBSim flight dynamics model and xml instructions to work in FlightGear. The geometry model is defined...
View ArticleIssues with logs
@darrell wrote: I did some bench testing with my plane yesterday to check the motors. After swapping a motor out I did the same tests but I can’t read the logs. The timestamp is Jan 1980 and there...
View ArticleTilt Quad VTOL with Payload more than 10 kg
@Jayanto_Halim wrote: Hi, I am planning currently to develop a VTOL airplane with payload 15 kg. The motors that I will be used are the P80 Motors from the T-Motor with CF 30x10.5" Propellers. The...
View ArticleAutotune can't seem to remove oscillations
@Montville wrote: Hello, I have moved my COG aftward and have since noticed that my aircraft oscillates in pitch quite drastically as soon as the speed reaches about 10-11m/s. (I did not fly in manual...
View ArticleClik here to view.
Wild 7 HZ oscillation with quad motors
@RogerR wrote: I did my first hover test with a mini-talon quadplane today. It “almost” worked. The plane lifted off, but had wild oscillations in motor speed and jerked around madly. With some luck,...
View ArticleLog File structure
@Sergey_Frolov wrote: Hello. How can I analyse *.bin log file. Where I can find description of log-file structure? Thanks Posts: 1 Participants: 1 Read full topic
View ArticleAutotune yes or no
@Schachti wrote: It always comes back to the question whether Autotune is good or not? What is your opinion about this? Posts: 1 Participants: 1 Read full topic
View ArticleQuadplane control backwards for qhover, but correct for plane
@RogerR wrote: (topic withdrawn by author, will be automatically deleted in 24 hours unless flagged) Posts: 1 Participants: 1 Read full topic
View Article