Max. possible flight time of V-Tol UAV
@111162 wrote: Hi, everyone We are developing a project that is to make a new type of UAV whose purpose is to observe and monitor land with the following spec. -Type : VTOL UAV, -Hybrid : Motor x 4...
View ArticleClik here to view.
Ardupilot Wind settings problem
@ujjwalrathod007 wrote: I am using Ardupilot with Plane and analyzing the log files. When I set the wind to 10m/s and from 180 degrees(south) I am getting some unwanted behaviour in WIND, I plot the...
View ArticleIntriguing fixed wing config question
@MerkaTony wrote: At the moment building a fixed wing that i would like it to have the following functions and wanted to know if anyone has ever done something similar, since after our google friend i...
View ArticleVectored tiltrotor
@vooteleaer wrote: I’m planning my next build, 4 motor tiltrotor - 2 motors on left wing and 2 on right. Wing center sections would be stationary and outer sections would be pivoting with motors....
View ArticleClik here to view.
Altitude snapped from baro to GPS alt - tried to crash
@evranch wrote: I just updated to 3.9.6 yesterday. I was attempting a survey pattern over my farm with Arduplane today, when suddenly my plane cut throttle and began gliding for the ground. A couple...
View ArticleRVjet, X8 or Nimbus 1800 all in VTOL
@hirobo wrote: Hi Friends, could you help make a decision? I am in doubt to mount RVjet, X8 or Nimbus all in Vtol. Load camere rgb and micasense and they can fly at 14m/s and autonomy of 1 hour or...
View ArticleSlower throttle response in AUTO modes
@Glen wrote: I would like my planes to be more efficient in AUTO modes. Unfortunately the throttle response for the TECS systems is so quick with modern ESCs that a lot of energy is wasted ramping up...
View ArticleI want to turn GPS around 180deg
@Ed_209 wrote: Hi all, I am still new to arduplane and getting my mini talon setup. I am using a Pixhawk 4 Mini and I would like to mount the GPS puck facing the rear of the plane due to the layout I...
View ArticleMove servo on flightmode (Plane)?
@MickeM wrote: Hi, I want to open a camera lid with the servo when putting the plane into Auto flightmode. I use RC-channel 5 out on the receiver for six flightmodes, one is auto. I want to close the...
View ArticleVTOL Auto takeoff issues
@lowlyelevated wrote: I’ve been testing a tiltrotor plane for fully autonomous missions: It takes off, flys, and lands without need for pilot input. I’ve run into a quirk of the AUTO mode vtol...
View ArticleMATEK F405 Wing - Current Sensor Battery Monitor Setup
@Alexander_Perez wrote: Hello. I’ve been exploring the new integration of F4 Omnibus boards within the ArduPilot ecosystem. I am currently using the latest version of ArduPlane 3.9 and the MATEK F405...
View ArticleClik here to view.
Nano Goblin VTOL project, help/advice needed
@justin.mader wrote: Howdy, Just getting acquainted with Ardupilot and have hit a few stumbling blocks. First, the setup: Arduplane 3.9.6 Strix Nano Goblin (580mm wingspan) Matek F405 Wing Spedix 45A...
View ArticleNo log on sd card
@Tony2k wrote: I really don’t know what happened, starting from yesterday I can’t have log on my sd. I tried with another sd, a clean flash and another Kakute f7. Sd card is fat32, I really don’t know...
View ArticleClik here to view.
Nano Goblin VTOL project, help/advice needed
@justin.mader wrote: Reposting here as it looks like this forum is more on topic. Howdy, Just getting acquainted with Ardupilot and have hit a few stumbling blocks. First, the setup: Arduplane 3.9.6...
View ArticleAPM 2.6 Analog inputs
@geqq wrote: Hello. I’m writting a new firmware for an APM 2.6.1 board. I want to read several analog values (DC inputs from 0 to 5v). I’m trying the following code but I’m getting random values...
View ArticleWing FC-10 DOF, GPS detection and booting
@Finncopter wrote: Not sure if this is hardware problem, bad flight controller, issues in settings or just normal feature. This is my first fixed wing rc-plane so now trying and learning. I’ve been...
View ArticleClik here to view.
Regarding the DO commands MAV_CMD_DO_REPEAT_SERVO and MAV_CMD_DO_REPEAT_RELAY
@PIXMAV wrote: Hello everyone，Regarding the DO commands MAV_CMD_DO_REPEAT_SERVO and MAV_CMD_DO_REPEAT_RELAY, can I set the relay channel and servo channel repeat trigger at the same time?...
View ArticleClik here to view.
Anormaly on survey mission, Plane follos some random trajectory
@Artem_Skorsky wrote: this is the first time I am having this problem, I gave survey mission to the plane, plane doesn’t follow survey points, flies like a drunk plane. weather was good, light wind....
View ArticleBicopter ardupilot firmware
@Christian_Reyner wrote: Hello, I’m new here. I ve been using apm and px4 for 4 years for various type vehicles (multirotor, plane, quadplane and tailsitter). Currently, i want to build bicopter vtol...
View ArticleQuadplane failsafe options
@jace26 wrote: So I’m concerned about my quadplane going into failsafe while in multicopter (MC) mode because unless it’s within the QRTL radius of home it will immediately try to transition into...
View Article