Precision Landing Parameter for fixed wing UAV
@zulazmi88 wrote: Hey guys, I am working on to improve autonomous landing for my fixed wing UAV since the landing is always overshoot. Based on my reading, I found out that I need to control the...
View ArticleMotores not spin when arming in 3.9.5
@Aticof wrote: With 3.9.4 the motors spin when arming in mu tricopter VTOL. I have updated to 3.9.5 and they do not do it anymore. I have increased Q_M_SPIN_ARM but they have not spin. Is there any...
View ArticleWeaving navigation
@hurzburg wrote: I recently started flying a MiniTalon that had been on the shelf a while…it performed navigation very well previously, as I recall…but recent flights have large periodic (~10-15sec...
View ArticleHELP! Unknown reason for plane crash during Manual
@uavdlsu wrote: Hi! Can anyone help us understand the cause of our plane crash last Jan 31, 2019? We were about to tune our newly built Skywalker but unfortunately, it crashed during Manual mode. In...
View ArticleVideo transmitter and long range antenna
@allen2 wrote: anyone please help me what camera and video transmitter is good for long range flight? thank you Posts: 1 Participants: 1 Read full topic
View ArticleHow to use Soar mode correctly on the flight controller Pixhawk 4?
@egunak95 wrote: I have Pixhawk 4 with firmware 3.9.4. I realized that this SOAR_ENABLE mode is implemented for AUTO, FBWB or CRUISE. How to build a flight plan AUTO there is also necessary for...
View ArticleAPM 2.8 Compass 1 Error: 99 [SOLVED]
@rish_go wrote: Hello, I’m using the APM 2.8 with a ublox NEO-M8N Gps module (with compass). In the initial setup I have chosen to use the external compass but upon live calibration, I receive the...
View ArticleClik here to view.
Arduplae without compass possible?
@aamadeuss wrote: hey i want to build a mini arduwing. http://www.mateksys.com/?portfolio=f405-wing www.banggood.com 8M M8N GPS Module for APM Pixhawk CC3D Naze32 F3 Flight Control for RC Drone Only...
View ArticleClik here to view.
How to adjust Speed Throttle auto mode, Arduplane 3.9.4
@andriaginting wrote: Hi, Please advise to adjust airplane speed in “Auto” Flight mode ? Currently I’m using Arduplane V3.9.4 and Pixhawk Flight Controller. Currently I only adjust the cruising speed...
View ArticleParameter Explaination(s) needed for tweeking an Auto Land Mission
@jstarch wrote: In hoping to fine tweek an Auto Land Mission I have a couple of parameter questions: If Increasing the TECS_LAND_SINK parameter in actuality shortens the flare point and in turn causes...
View ArticlePlane changes flightmode without any interaction
@KadaverJoe wrote: Today I had a bad crash with my Plane. It changed the flightmode from an auto mission to manual flight mode and crashed, I had a look at the telemetry log and I am very confused. It...
View ArticleNew Radio transmitter - throttle control only available in manual, not FBWA,...
@f4corsair wrote: I have been using the same Spectrum Dx6i for years. Upgraded to a newer Spektrum 6 and ran through the calibration routine in Mission Planner. While flying today, everything worked...
View ArticleLogging and Terrain Data Chibi-OS Arduplane, Matek F405-W
@andriaginting wrote: Hi, Could anyone advise, what Firmware version for Matek F405-W Flight controller that support Logging and Terrain data ? Currently i’m using the controller in my Mini Talon and...
View ArticleDual GPS- second GPS not detected?
@wazoo22 wrote: I’m using a Pixhawk 1 with mission planner 1.3.2 and AP 3.9.5, two GPS’s, one BN880 on the regular gps port and the other BN280 on serial4/5, with serial 4 set to 38k, protocall...
View ArticleGUIDED_NOGPS for Plane?
@HITMAnsOFT wrote: Hi, In my project I need to control the attitude of a plane from a companion computer. I’m currently using RC_CHANNELS_OVERRIDE message in FBWA mode for this, which is hacky and...
View ArticleClik here to view.
TeraRanger Evo not working on ArduPlane
@freedom718 wrote: Good day everyone, I have a question regarding about the TeraRanger Evo and that is does it work with ArduPlane 3.9.5? as i have connected the teraranger evo to a pixhawk 4 and...
View ArticleArduplane, Dead Roll after Switch to Auto Mode
@andriaginting wrote: Hi, I’m using Matek F405W and use Chibi OS Arduplane. I inserted SDCard and logging properly. I’m often use my HDWing to do mission and succeed without any problem. Yesterday i...
View ArticleExpected mode after failsafe recovery?
@iforce2d wrote: I just had the hardest crash of my RC history to date, due to what I would consider an inconsistency in the flight mode state after failsafe recovery. I had to write off a brand new...
View ArticleClik here to view.
ArduPlane JSBSim Synchronization/Lock-Step-Mechanism Issues
@simfinite wrote: Hey everyone, i have experienced some synchronization issues between JSBSim and ArduPlane SITL, which I would like to discuss here before opening an issue. I have modified the JSBSim...
View ArticleBad GPS SiGNAL Health
@Charrua wrote: Hi, I’m setting up a pixhawk cube 2 on my skywalker x8 and I’m having a gps signal problem, I’m using firmware 3.9.5, I have everything worked but I get the message from (Bad Gps...
View Article