Arduplane 4 Massive Altitude Drift when stationary
@dzienj wrote: It’s my first post here so Hello Everyone. I’m trying to find a resolution to the misterious issue I came accross related to the altitude reading of my Ardupilot, and before I blame it...
View ArticleClik here to view.
VTOL Tandem Tilt-Wing with 8 Propellers
@seth_poh wrote: Hi all, I am interested in implementing a VTOL tandem wing platform with 8 propellers. The platform that I have in mind closely follows the Airbus Vahana and the NASA LA-8 Aerodrome....
View ArticleCan we RTL in case of GPS Jamming?
@Sunny52266 wrote: Hi, I hope its not a dumb question. Is there any way to program return to launch and its accuracy in case GPS signal is being jammed for some reason? Posts: 2 Participants: 2 Read...
View ArticleBudget FC for VTOL plane
@ilia123 wrote: Hello, I am looking to buy some budget FC for VTOL. My plane has: motor 1, motor 2, motor 3, motor 4, Pusher motor Right elevon, Left elevon, Rudder, Throttle It’s small vtol for...
View ArticleMy first FPV Plane
@Flierman1945 wrote: I have been a copter flier for a fair few years and did try Plane on an old APM board, but that was not too good. So now with the lockdown, I decided to retry Plane fpv. So I have...
View ArticleMultiple failsafes with good rssi (help needed interpreting the log)
@Fasa wrote: Hi, sorry to bother you all with this, but i´m not sure what to search for in the logs. (And i’m also a total newbie with ardupilot.) Last Saturday i have flown twice this rig, the first...
View ArticleMatek H743 Initializes only after sitting for 15 minutes
@fordp wrote: I setup my H743 with m8q-can and r9 F.Port receiver. I flashed the 2mb blank file with STM32CubeProgrammer then 4.1.0 beta arduplane_with_bl.hex. I have tried various stables and...
View ArticleF405-Wing: How to connect GPS to UART4?
@jCat wrote: Hi, I am tring to wire my plane by sugguested “F405-WING General Wiring figure” (http://www.mateksys.com/?portfolio=f405-wing#tab-id-3). This figure is for INAV, I am using ardupilot with...
View ArticleClik here to view.
Skywalker X-8 VTOL Conversion - My Way!
@jacques_eloff wrote: It has been a whilst since I last built a VTOL and I thought I would share some info on my latest project, a Skywalker X-8 conversion. The basic (fixed wing only) aircraft is...
View ArticleQuadplane RTL/QRTL behavior at low altitude, Danger!
@lowlyelevated wrote: Hello all, I have a question regarding how the RTL/QRTL handover behaves when hovering at low altitude. The aircraft of todays issue is a tiltrotor quadplane running firmware...
View ArticleCan you passthrough blheli_32 on serial1 (NOT USB)?
@Tenns wrote: Hello, I was trying to setup blheli_32 passthrough on serial1 after having successfully done it via usb. But it does not connect (blheli_32 just freezes), can it be done? Should i change...
View ArticleQuadplane with rudder only has mixed controls in QSTAB
@pfaudette wrote: I’m just finishing up an FT Explorer conversion into a quadplane, and had my first QSTABILIZE flight. The plane is a rudder & elevator control only (no aileron servos), but when...
View ArticleQuestion on plane RTL on QGC
@alvinc wrote: Hi there, I was flying a mapping mission with auto takeoff and landing using QGC, half way through I decided to test the RTL function by clicking “Return”, however the plane did not...
View ArticleCannot disarm plane
@Constantin_Marcel wrote: Hello, I am using arduplane version 4.0.6. Unfortunately, I can not figure out how to disarm the plane. Arming works fine with the included arm button. Disarming doesn’t...
View ArticleHow to use the synthetic airspeed?
@RCnorm wrote: Hi there! I am a bit confused to use the synthetic airspeed for a plane. The plane manual’s “Using an Airspeed Sensor” section says “if there is no sensor, be sure to set the ARSPD_TYPE...
View ArticleWhat was the issue here? Strange behaviour
@itsnotme wrote: Hi guys, I just did a test with one of my planes and I had an issue. I lost the RC and instead of returning to home, the plane passed home point and flies away another 500m and start...
View ArticleServo size tilting motor
@rsflyg wrote: HI! I wonder what size the tilting servo should have, if tilting a motor with about 19-21 inch prop? Posts: 1 Participants: 1 Read full topic
View ArticleI have a feeling this is a dumb question, but here goes:
@wazoo22 wrote: I 'm setting up a Wing-wing with an Omnibus F4ProV3, latest AP and MP. I set it up with standard travels in manual mode- about 4mm up and 3mm down, neutral at 1-2mm reflex. When I...
View ArticleTelemetry randomly works
@Fugazi wrote: Hi, when I plug my flight controller in sometimes the telemetry works perfectly and sometimes just doesnt work, probably 2 of 3 times it doesnt work… Matek H743 R9M MM Taranis X9D Any...
View ArticleUAVCAN based GPS is not detected
@wucke13 wrote: Hi there, I’m having trouble bringing my GNSS to life. The GNSS turns on and eventually finds a fix (indicated by green LED switching on for a few ms at roughly 1 Hz). However, it...
View Article