@RCnorm wrote:
Hi there!
I am a bit confused to use the synthetic airspeed for a plane.
The plane manual’s “Using an Airspeed Sensor” section says “if there is no sensor, be sure to set the ARSPD_TYPE to 0. ArduPilot calculates an sensor-less airspeed estimate that is used if no sensor is present or fails.” This sentense seems to say the synthetic airspeed is used if only the ARSPD_TYPE is set to 0.
But I found there is one more parameter the TECS_SYNAIRSPEED. The complete parameter list says this parameter is used to “enable the use of synthetic airspeed”My question is “Is it necessary to use both parameters or only one parameter is enough to use the synthetic airspeed?”
Posts: 1
Participants: 1