Clik here to view.
BL Heli_32 Talon ESC pass through Issue - Matek 405 Wing
@craigy72 wrote: Hello All, I’m having trouble connecting BL Helo_32 Suite to my ESC via Ardupilot (4.0.5) pass through. Below are my settings in Ardu. Capture2411×480 179 KB I’m using the latest...
View ArticleMotor not starting? Throttle not working
@jbdrones wrote: Hi Everyone, First off, I just want to say that I appreciate any help in advance because I am driving myself crazy trying to figure this out. Basically, I am trying to setup a simple...
View ArticleDesign thinking behind Arduplane BATT_WATT_MAX
@MCITYFC wrote: Hi guys I tried using using the BATT_WATT_MAX parameter to limit the power output of my plane, especially when it’s initially on a full battery and performing a climb. The Motor is...
View ArticleClik here to view.
Would appretiate log analysis help for best cruise speed and stall speed
@rsilvers wrote: My goal is to do long range autonomous missions, so I want to find the best cruise speed. This is an RMRC Recruit with a Matek 765 and an Airspeed sensor. Battery was “2200” 3S LiPo....
View ArticleX-UAV Talon 2000 mm (with wing extension)
@Shubham_Thakur wrote: Hey there! I hope you guys are at home and safe. These are some difficult times. Anyways, I just recieced an X-UAV Talon with wing extension and I intend to use it for mapping...
View ArticleHow to configure ArduPlane for V-Tail glider?
@wazoo22 wrote: This will be my first AP v-tail glider, but I can’t find anywhere in the wiki information on how to set up a v-tail. Yes, the servo functions are there, but the scraps of setup...
View ArticleLoop in Stabilize Mode Causes FC to Lose Orientation and Inverted Flight?
@Travm1982 wrote: While flying my Ritewing Z2.5 in stabilize mode I attempted a loop. The autopilot took over at 90 degrees pitch up and completely overrode my inputs. The plane performed a radical...
View ArticleClik here to view.
FS_Options missing from Mission Planner Advance Parameter
@RizHass wrote: I cannot find FS_options in the Advance Parameter tree on MP. Ardupilot document list this parameter: Posts: 1 Participants: 1 Read full topic
View ArticlePID Controller Question
@Tudole wrote: Hi, I am pretty new to ArduPlane and I have some question regarding the PID controller. As the document described, the ki gain is in the down stream of the rate error. That will make...
View ArticleLoss Altitude in Stabilize mode
@Peter2 wrote: Hi everyone… My plane was flying amazing yesterday… But today after 100 alt it was loss altitude in stabilize mode… Any idea Posts: 2 Participants: 2 Read full topic
View ArticleCan auto takeoff be used in lieu of CTOL in manual mode?
@spetsnaz26 wrote: i have a tricycle airplane that is too difficult to control on ground. Directional control is divergent outside maybe one or two degree of rudder stick throw and the amount of...
View ArticlePlease post a .tlog with RPM data
@Andre-K wrote: I am making a warning system for engine cut, so if anyone can please post a log with RPM, it would help. It does not need to be a flight, bench-testing ok, RPM changes and start stops...
View ArticleIC engine without RC radio
@Lars_Meadoworth wrote: Is there a way to operate an IC ignition without a physical RC switch? I use a GCS with no RC all the time on electric motors, but I can’t seem to find a way to get the IC...
View ArticleShaking up and down
@rsilvers wrote: I have an ARWing and a servo was damaged in a crash where the gear stripped. I replaced that one cheap analog servo with a digital metal gear servo. I knew I should probably replace...
View ArticlePlane disarm in Air
@Peter2 wrote: Hi guys… in the last flight, when the plane was fly, I saw No RC Receiver warning and after then Disarmed in the air. Any idea please Posts: 6 Participants: 2 Read full topic
View ArticlePlane suddenly shaking up and down
@Engnr_Mirza_Khurram wrote: https://drive.google.com/file/d/1F7U0bQtqnyeWgW9zVqFgHE4S-txf4peS/view?usp=sharing we are using plane v 4.0.5 on Elevone plane setup I can take off in ,FBWA, mode the plane...
View ArticleHow is canonical altitude calculated?
@TomOReilly wrote: Does anyone know exactly how altitude is calculated for canonical position (POS message)? I assume it’s a combination of barometer and GPS altitude data, weighted toward barometer....
View ArticleTelemetry I vs Telemetry II: Telemetry II Not Display AHRS
@Todd_Stubblebine wrote: Hello, I wanted to reach out and see if anyone could help troubleshoot a technicality that I’m experiencing. I’m running two telemetry units on a Pixhawk 2.1 Black Cube:...
View ArticleClik here to view.
For Gliders/Soaring: How to prioritize airspeed over altitude control in...
@ohitstarik wrote: Hey! So i’m trying to glide from waypoint to waypoint. One problem i’ve come across is keeping a solid pitch angle and maintaining a consistent airspeed. When my aircraft is below...
View ArticleVtol 2 motors Airship
@Theo_Hoenen1 wrote: Hello everybody , I am currently working on a Vtol airship with 2 motors. What setup ( hardware and software ) would you advise for this configuration. I made some research on...
View Article