@GerdG wrote:
I try to set up a Matek 743 with the latest firmware and APM. I followed exactly the documentation and used the STM32 tool to install arduplane_with_bl.hex form MatekM743 firmware folder. This step finished (two times) without any problem on a Ubuntu PC. When I connect with APM to the Matek743, I can configure the the Matek (CONFIG/TUNING tab) but I cannot do the “Initial Setup” step. When I hit “Install Firmware”, I always get the message “no valid device found”.
I hesitate to continue, because I’m not sure if it really works. Although it seems to be possible to configure the Matek board.
thanks for any help, regards, Gerd
Posts: 1
Participants: 1