@Maciek_S wrote:
Hey,
I am making a new setup with a new plane. I reflashed my Matek H743 - it happens the same thing with both arduplane 4.0.8 and 4.1. I configured that via MissionPlanner (ranges, calibrations and in parameters only disabled arming required)
Once I connect battery up, motor makes intro sound but only a single one. Receiver and transmitter connects - however it takes like 5-6 seconds once the servos start to respond. There is no any further sound of a motor and it does not react on throttle stick movement - only servos work. No USB connection at this point.
When I disconnect battery and as first power up via USB, open up a Mission planner, plug in the battery then motor play intro sound followed by few tones showing it is ready to work - and it does work.
When I bypass entire FB it works right away, it arms and spins.
I checked it on the separate set of a motor and esc and the very same thing happens.In summary it seems, like only after connection to PC motor works. Any ideas why?
Posts: 7
Participants: 2