@clev0910 wrote:
I have setup AirSim with the landscape mountains environment and have also set up SITL using Cygwin. However, when I attempt to run SITL in order to move the quadcopter around on unreal engine, while I do get MAVlink, the map and the console to open, any commands that I type into the MAVlink have no effect on the quadcopter; it does not arm nor takeoff or do anything after that. I do receive a message as I attempt to start SITL, an image of which I’ve attached below. I’ve also attached the settings I’ve used in the .json settings folder for the Unreal Project. Is there any change that needs to be made to the settings/SITL set up?
[
Posts: 1
Participants: 1