Motor arming issue (continuously beeping) on pixhawk and mission planner

@Shubham_Thakur wrote:

Hello, I am building a arduplane on new skywalker aircraft.

Configuration:
Motor:- T-motor AT 2820 830kv
ESC:- T-motor T60A 400Hz
FC:- Pixhawk 2.4.8
GS:- Mission Planner
tx/rx:- Taranis QX7/L9R

Issue:-
Everything seems to be working fine except for ESC and Motor is continuously beeping with pixhawk blinking yellow repeatedly. There’s a slow beep on powering the pixhawk and when I push the switch the beeping speeds up. There is no pre-arm failure.

I Calibrated the ESC by connecting it to 3rd channel of receiver. The esc and motor are working fine. The issue arises when I connect it to the pixhawk. Is there any parameter I should change. I can’t find any solution to this on other threads. It’s very frustrating as I am looking for a solution since 3 days. Is there anything I should do with ESC. Am I missing anything?
Please help
Thanks in advance.

here is the link to the video of the issue.

Posts: 1

Participants: 1

Read full topic