Quantcast
Channel: ArduPlane - ArduPilot Discourse
Viewing all articles
Browse latest Browse all 7900

No contact between pixhawk and Rx after load 4.01

$
0
0

@wazoo22 wrote:

Hello all. weird stuff today.
I’m using a pixhawk with latest MP. and ppm 12 channel, Graupner GR-24 Rx and mx-20 Tx.
I installed 4.01 and MP says, “no RC”.
Rx/Rc works fine driving a servo direct. The Pixhawk just does not see it somehow. Even stranger, no control surface movements as you would expect, , but I can switch cameras!
The entire system worked fine yesterday. The only thing I did was load 4.01.

Posts: 1

Participants: 1

Read full topic


Viewing all articles
Browse latest Browse all 7900

Latest Images

Trending Articles



Latest Images