@woogie_man wrote:
I am trying to get my Matek F405 CTR board set up with mission planner, and I am unable to get the program to see the voltage. Attempted to go through the wiki page, but still unable to figure it out.
Any thoughts?
I did just try and loading these parameters into mission planner… and nothing
it should work out of the box, the params are:
BATT_AMP_PERVLT 31.7
BATT_CURR_PIN,11
BATT_VOLT_MULT,11
BATT_VOLT_PIN,10
Posts: 1
Participants: 1