@Gclements10 wrote:
Bought a new 4525D digital Airspeed Sensor to use with a fixed wing glider. I have a pixhawk 4 flight controller and have connected the sensor directly to the I2C Port. I’ve set the Airspeed pin parameter to 65, the Airspeed use parameter to 1, and have set the right type of sensor in initial setup. The airspeed reading oscillates between 0-1 m/s even if I blow on. I have tried pre flight calibration and it still does not work. Do I need to connect this to the I2C B Port or change any other parameters to get it to work?
Posts: 3
Participants: 2