@Ivosch wrote:
Hello,
I have some experience with Arducopter configuration and now I’am building elevon - delta wing using same controller/ pixhawk clone. I have downloaded latest firmware ArduPlane V3.8.5. Initial configuration was ok but I can’t arm the plane.
- When I’m following wiki - throttle down + rudder right nothing happens. I was used to hear sound when copter was disarmed and message appeared about safety switch. When I hold safety switch to arm the plane, safety switch LED stops to blink and is on. I can control left and right Elevon (servo outputs 1 and 2). Mixing is ok. But Mission Planner still shows Disarmed status. Still it is no possible control servo 3 output - throttle.
- I’m still getting “Bad or No Terrain Data”. All serial ports are configured to Mavlink protocol or disabled - no GPS configuration. Arm check is disabled (ARMING_CHECK 0).
Any ideas?
Posts: 1
Participants: 1