@Luis wrote:
Hi all ,
I am a new user of pixhawk mini FC. I have used APM planner to install Arduplane 3.8 for a new project of FPV fixed wing.
After initial setup, all it is OK except ESC calibration. When I turn on arm switch, ESC beep continually ( this ESC works fine when is calibrated with the receiver)
After a lot of test and reading post about this issue I do not get solve this problem. I use Turnigy 30A ESC with BEC and I test other two different ESC ( kontronik and Simon). I have modified PWM minimum and maximum values in SERVO throttle channel without results.
Someone could help me? Are there some ESC kind recommended?
Posts: 11
Participants: 3