@RichB wrote:
Hi All,
My first post!
I upgraded last night to 3.8, after a reboot, my vtail setup had changed, I've since sorted this with a very comprehensive explanation document in plane.
I have since noticed another problem which I cannot seem to fathom out, when I connect the power supply, the pixhawk boots up perfectly, then I expect no output to the servos until the safety switch is pressed, when I checked to make sure I had no signal to the servos by moving my transmitter sticks the right Vtail moved up and down.The safety switch is flashing to show a safe state, nothing else moves or operates, the throttle is safe, just the right hand Vtail moves. When I press the safety switch the light goes solid red and everything operates as normal and I am able to arm the motor.
Many thanks for you help
RichB
Posts: 2
Participants: 2
