@Jono2014 wrote:
Would appreciate any help with another plane crash in Auto mode. My Twin Dream (twin prop plane) with Attopilot 90amp current sensor, TBS Crossfire Rx and Tx running 8 channels and using Pixhawk telemetry 2 input/output. Attopilot requires some fine-tuning so some of the voltage readings are incorrect. Plane flew fine until around 10min into the flight where it went into a sudden downward spiral from 100m in Auto mode. High amps used after it hit the ground as one motor continued spinning until it was put into manual mode using the RC.
A link to the log is attached below:
https://www.dropbox.com/s/lwppwbkmzf2ro9x/14.BIN?dl=0All help appreciated
Posts: 1
Participants: 1