@garrett_min wrote:
RCEXEL OPTO IGNITION KILL SWITCH FAILS WHILE RC5_OUT = PWM
RC5_OUT = PWM 2134 - 900Previous version of Arduplane had no fail with RCEXEL Opto Switch.
3.7 will not switch a NEW & OLD RCEXEL Switch or LED on RC5_OUT w/ PWM verified.
3.7 will turn a Servo on RC5_OUT w/ PWM verified.
Both Switches were tested success with Frsky X8R on Ch 5 w/ SBUS Unplugged
Both Switches were tested fail with Frsky X8R on Ch5 w/ SBUS plugged in at same time.
Suggestions?
I set BRD_SBUS_OUT to 1,2,3,4,5,6 & 7 w/ reboot & no result.
I set BRD_SBUS_OUT to 1,2,3,4,5,6,7 without rebooting & no result.I set on ICE channel to exact PWM Ignition On/Off & no result.
Explanation?
Why will RC5_OUT drive a Servo but not drive a RCEXEL Opto Switch?
Why will X8R drive a RCEXEL Opto Switch but not a Pixhawk drive a RCEXEL with same PWM values on Ch5/RC5_OUT?
Posts: 1
Participants: 1