@Steven_Young wrote:
Good afternoon,
Today whilst benchtesting I had internal error message – I was not able to capture it with photo and the Tlog for the event did not seen to save so the exact error I cannot say. I do however have 2x BIN files in the attached folder they are relatively small.
F/C - Cube Black in standard carrier board
Firmware - Ardu Plane 4.0.9
Aircraft - Foxtech Nimbus V2 Tilt Motor
Mission Planner - Latest stableAt the time bench test in manual mode, using MP switched to FBWA/B not sure which tilt motor moved to 45deg as expected, switched back to manual model error occurred and plane went into failsafe mode ? QLand / though still stated Manual in Mission planner.
https://drive.google.com/drive/folders/1p0-MH65kHbKp1ntUi9HFWLeHbL791wSR?usp=sharing
Not sure if this should be posted elseware
Steve
Posts: 2
Participants: 1