@ardudmy wrote:
Hi everyone. I’ve been running Crossfire on my Betaflight quads for a long time and I am familiar with the system. I am new to Ardupilot though. I have a Matek F765-WING which I have flashed with Arduplane 4.1.0 because of Crossfire connectivity - hoping I am right so far. I am not interested in RC over Mavlink.
On the Crossfire Tx (running 4.11) I have set Channel 8 to CRSF TX and Channel 7 to CRSF Rx.
Wired signal pin of channel 8 to RX3 on the Matek
Wired signal pin of channel 7 to TX3 on the Matek
In Misson Planner the only thing I have changed is to set SERIAL3_PROTOCOL to 23 (RCIN)I have no reaction to stick movements in both Setup->Radio Calibration and Setup->Servo Output
What am I missing?
Many thanks for your support in advance!
Posts: 4
Participants: 3