Help with airspeed sensor

@Lbarreiro wrote:

Hi

I’m having trouble installing a airspeed sensor via I2C port on pixhawk cube with the last firmware.
I have one as show in ardupilot instructions for plane and followed all the steps without success.
I used for the ARSPD_PIN the value off 15 and 65, for the ARSPD_BUS the value 0, 1 and 3, and for the ARSP_TYPE chose all the sensor available.
I also check the connections, VCC, ground, SCL and SDA, it seems all okay.
Any ideas?
The mission planner don’t show any readings in all the combinations.

Thanks

Posts: 1

Participants: 1

Read full topic