Quantcast
Channel: ArduPlane - ArduPilot Discourse
Viewing all articles
Browse latest Browse all 7844

Parameter Changes

$
0
0

@thatsnailguy wrote:

Hello,

Why change batt_amp_pervolt to batt_amp_pervlt? Also why the changes to FS_Batt_Voltage?

Also, am I alone in not liking the use of expandable parameters. I have to enable battery monitor, then reboot to configure the monitor. Previously I did not have to. This type of parameter roll up makes sense for things like q_modes but surely most people will use battery monitor and the added reboot during programming is annoying. If there is a technical reason for this, my apologies, but if this is an attempt at QOL improvement, I do not like it.

Also, where can I download 3.8.5 in the historical repo only the latest is saved, not stable, as far as I can tell.

Thanks,
Travis

Posts: 4

Participants: 3

Read full topic


Viewing all articles
Browse latest Browse all 7844

Trending Articles